Electrix Framing System Manuel d'utilisateur télécharger pdf (Page 3)

3

G

H

J

10. Apply Corner Bead and “J” Bead at Top and

Bottom Corners. (Figures L&M). Finish

inside wall corner with compound and tape

(not supplied).

K

L

M

9. Cut and apply Front Face with the

appropriate sheetrock screws (not supplied)

(Figure K). 2-1/2” recommended face height

but may vary. Line of sight issues must be

addressed by architect. Note overhang of

front face. (Figure L). This ensures clean

corner seams. (Figure M).

7. Cut Sheetrock (by others) between

6-3/4”—6-7/8” width and apply as Bottom

Face. Use the appropriate sheetrock

screws (not provided):

• 1” Maximum for 1/2” Sheetrock

• 1-1/4” Maximum for 5/8” Sheetrock

Screw in vertically at front. (Figure G).

Screws at rear are slightly angled. (Figure H)

.

8. Bottom face installed. Ready for front face

installation. (Figure J). Note the 1/2”

support for the vertical face.

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire